Troubleshooting - Brother P-touch E110VP User Manual

Troubleshooting

 Error messages

Message
The batteries are weak.
Battery
If using AAA alkaline batteries,
Low!
replace them with new ones
(do not use a combination of old
and new batteries).
If using Ni-MH batteries, charge
them fully.
The installed batteries are
Battery
exhausted and need to be replaced
Empty!
for continued operation.
Invalid! • An invalid number was entered as
the label length, cable diameter,
flag length or faceplate length.
• An invalid letter or number to be
incremented was selected in the
Serialize function.
No Text! • You tried to print a text file when
there is no data stored in the
memory.
•
entered.
• +
text is entered.
•
entered.
• or
text was entered while using
templates.
• You tried to enter a third line by
2 Line
Limit! /
pressing
1 Line
Limit!
• You tried to print or preview two
lines of text while 3.5 mm or 6 mm
tape was installed. Install a larger
tape size.
There is no cassette installed.
No
Install a cassette with the
Cassette!
or
Cause / Remedy
is pressed when no text is
is pressed when no
is pressed when no text is
was pressed when no
.
mark.
Message
Cutter
Pressed
Text
Full!
Text
Limit!
Change
Length
Feed OK? Tape was fed after printing when
Wrong
Tape!
Use TZe
tape
mark
Cause / Remedy
The Tape Cutter Lever was
pressed in the middle of the printing
process.
The maximum number of
characters (80 characters for text)
have already been entered.
You may have exceeded the set
tape length. Reduce the text or
select [Auto] as the tape length.
[Chain Print] was selected. For
more information, see the Setting
Margins section.
Use a cassette with the
mark.
mark or