Table of Contents
Advertisement
Contents
Introduction
2
Read this manual carefully before attempting to install, oper-
3
ate, or perform maintenance on this unit. Installation and
3
maintenance should be performed by qualified service techni-
4
cians only. Do NOT use this furnace for temporary heating of
buildings under construction.
10
11
As shipped from the factory, this unit is for use with natural gas
11
only. It is listed by Underwriters Laboratory. An LP Gas conver-
11
sion kit is available. Extreme mounting kits for slab and curbs
11
are also available.
11
11
Packaged units are designed for outdoor mounting with a
12
vertical condenser discharge. They can be located either at
12
ground level or on a roof in accordance with local codes or
13
National Fuel Gas Code (ANSI-Z223.1A) Latest Revision.
13
Since these units are designed exclusively for outdoor opera-
16
tion, additional flue venting systems are not required. Each
16
unit contains an operating charge of refrigerant as shipped.
16
Extreme mounting kits are available for slab (BAYEX-
16
MK003A), utility curb (BAYEXMK002B), or curb (BAYEX-
16
MK001A) mountings.
17
17
The indoor fan motor speed adjustment is provided in the
17
Service Maintenance section on page 25.
17
This guide is organized as follows:
18
18
Step 1- Inspect Shipment
19
Step 2- Determine Unit Clearances
19
19
Step 3- Review Location and Recommendation Information
19
Step 4- Unit Installation
20
20
Step 5- Unit Startup
20
Sequence of Operation
20
Maintenance
20
21
Note:
The packaged units have been evaluated in
22
accordance with the Code of Federal Regulations,
22
Chapter XX, Part 3280 or the equivalent.
22
"SUITABLE FOR MOBILE HOME USE".
22
22
Step 1-Inspect Shipment
22
22
1. Check for damage after the unit is unloaded. Report promptly
23
to the carrier any damage found to the unit. Do not drop the
23
unit.
24
IMPORTANT: To prevent damage to the sides and top of
25
the unit when hoisting, use "spreader bars" as shown on
25
page 13.
25
2. Check the unit's nameplate to determine if the unit is cor-
25
rect for the intended application. The power supply must be
25
adequate for the unit and all accessories.
25
3. Check to be sure the refrigerant charge has been retained
26
during shipment. Remove the Compressor access panel to
access the 1/4" flare pressure taps.
4. The Flue Hood is included with the unit's literature pack.
5. If this unit is being installed on a curb, verify that the correct
curb is provided for the unit.
•
4YCY4024-036 use model BAYCURB050A.
•
4YCY4042-060 use model BAYCURB051A.
6. If the unit is being hoisted, accessory kit BAYLIFT002B is
recommended. It includes a kit of four (4) lifting lugs and
instructions.
NOTE: If practical, install any internal accessories to the
unit at the shop.
Installer's Guide
Page 3
Advertisement
Table of Contents
