Panasonic CS-Z35UFRAW Service Manual page 43

12.1.3.1.5 Indoor unit installation

For floor installations, secure the indoor unit using 6 screws.

For wall installations, secure the mounting plate using 7 screws and the indoor unit using 4 screws.
Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the
o
drilling points on the wall.

Once refrigerant piping and drain piping connections are complete, fill in the gap of the through hole with putty. A
gap can lead to condensation on the refrigerant pipe, and drain pipe, and the entry of insects into the pipes.

Attach the front panel and front grille by following the removal procedure in reverse once all connections are
complete.
Floor Installation
To access these 2 locations,
long screw driver is required.
6 screws 2
(M4 × 25L)
12.1.3.2 Half concealed installation

Only item peculiar to this installation method are given here. See Exposed installation for additional instructions.
12.1.3.2.1 Wall hole

Drill a wall hole of the size shown in the illustration
on the right.
12.1.3.2.2 Installation of supplemental plate for attaching indoor unit

The rear of the unit can be fixed with screws at the points shown in the illustration as below. Be sure to install the
supplemental plate in accordance with the depth of the inner wall.
Fixing point
on the back
CAUTION
• The supplemental plate for installing the main unit must be used, or there will be a gap between the unit and the wall.
Wall Installation
To access these 2 locations,
long screw driver is required.
Casing
4 screws 2
(M4 × 25L)
CAUTION
The mounting plate should be installed on a wall
which can support the weight of the indoor unit.
720
Screw hole
135
265
Opening hole
Supplemental plate
(Locally purchased)
Mounting
plate 1
7 screws 2
(M4 × 25L)
Molding
Open size
Floor
Screw hole
90
230
43
• Location for securing the mounting plate.
742-746 (Unit: mm)
Opening hole
50
(Unit: mm)
Supplemental plate
(Locally purchased)
250
200
(Unit: mm)