Table of Contents
Advertisement
en
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
Displays do not
illuminate.
The light does not
function.
The refrigerating unit
is switching on more
frequently and for
longer.
Appliance is not
cooling, temperature
display and light
are lit.
28
Possible cause
Power failure; the fuse
has been switched off;
the mains plug has not
been inserted
properly.
The LED light is
defective.
Appliance was open
too long.
Light is switched off
after approx. 10 min.
Appliance opened
frequently.
The ventilation
openings have been
covered.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate to
switch off the appliance for
5 minutes.
If the temperature is too high wait a
few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether
the power is on, check the fuses.
See chapter "Light (LED)" section.
When the appliance is closed and
opened, the light is on again.
Do not open the appliance
unnecessarily.
Remove obstacles.
Hold down alarm button 2/5 for
10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
Advertisement
Table of Contents
