Advertisement
3.2.6 DISASSEMBLY of [17] MONITOR ASSEMBLY
Disassembly of MONITOR ASSEMBLY
(1) Remove the three screws (1-4), and remove the MONI-
TOR COVER ASSEMBLY by disengaging the five hooks
(L17a-e).
NOTE17a:
When removing, be careful not to damage the hooks.
(2) Pull out the U/D SWITCH BOARD from the MONITOR
CASE ASSEMBLY.
NOTE17b:
When attaching, make sure to place the FPC over the
HINGE ASSEMBLY, and set it in the slot of the MON-
ITOR CASE.
(3) Release the lock of the connector(CN17a,b), and re-
move the HINGE ASSEMBLY by pulling it up.
NOTE17c:
During the procedure, be careful in handling the FPC.
When attaching, make sure to place the CN17b under.
(4) Release the lock of the connector (CN17c), and pull out
the FPC.
(5) Remove the screw (5).
(6) Remove the MONI BL BOARD ASSEMBLY and the
BACK LIGHT together.
NOTE17d:
Since the BACKLIGHT is soldered to the BOARD AS-
SEMBLY (SD17), they should be removed together
except for the replacement.
(7) Remove the SHEET (DIFF. ) and the SHEET (BEF).
(8) Remove the LCD MODULE.
(9) Remove the BKT(LCD) ASSY.
1-16 (No.YF091)
<NOTE17a>
L17c
L17d
L17a
L17b
MONITOR
COVER ASSY
NOTE17a
3
(S17b)
4
(S17b)
NOTE17c
HINGE UNIT
a
ASSY
b
L17e
U/D SW
BOARD ASSY
NOTE17b
5
CN17c
(S17c)
d
c
e
c
d
e
Fig.3-2-6
<NOTE17c>
FPC
1
(S17a)
2
(S17a)
CN17b
CN17a
a
a
c
b
<NOTE17b>
FPC
MONI BL
BOARD ASSY
NOTE17d
SD17
BACKLIGHT ASSY
NOTE17d
SHEET(DIFF.)
SHEET(BEF)
LCD MODULE
BKT(LCD) ASSY
L17g
MONITOR CASE
0.078N m (0.8kgf cm)
0.198N m (2.0kgf cm)
Advertisement
