Bosch WTE843S1GB Installation Instructions, Instructions for Use, Programme Table Instruction Manual

Intended use
Your new dryer
Congratulations - You have chosen a modern, high-quality Bosch for domestic use only,
domestic appliance. only to be used for drying fabrics that have been
The condensation dryer is distinguished by its economical energy washed with water.
consumption.
Every dryer which leaves our factory is carefully checked to ensure
that it functions correctly and is in perfect condition.
Do not leave children unsupervised near the dryer.
Should you have any questions, our after-sales service will be pleased
Keep pets away from the dryer.
to help.
Disposal in an environmentally-responsible manner
Dispose of packaging in an environmentally-responsible manner.
This appliance is labelled in accordance with the European
guideline 2002/96/EG on waste electrical and electronic
equipment - WEEE.
The guideline provides an EU-wide framework for the return and
recycling of old appliances.
For further information about our products, accessories, spare parts
and services, please visit: www.bosch-home.com
Observe the safety instructions on page 13.
Read these instructions before operating the dryer.
Additional Display panel Time
functions remaining
Contents
Page
Preparation . . . . . . . . . . . . . . . . . . . . . . 2
Setting the programmes . . . . . . . . . . . . . 2
Drying . . . . . . . . . . . . . . . . . . . . . . . . 3/4
Information on laundry . . . . . . . . . . . . . . 5
Care and cleaning . . . . . . . . . . . . . . . . . 6
Programme overview . . . . . . . . . . . . . . . . 7
Installation . . . . . . . . . . . . . . . . . . . . . . . . 8
Frost protection / Transport . . . . . . . . . . . 8
Technical data . . . . . . . . . . . . . . . . . . . . 9
Optional accessories . . . . . . . . . . . . . . . . 9
What to do if... / After-sales service . . . . 10
h:min
Safety instructions . . . . . . . . . . . . . . . . 11
Service displays
Container Empty the condensation container.
Filter
Clean the fluff filter and/or air cooler
Buzzer Select On/Off for a acoustic signal at end of programme.
Low Heat Reduced temperature for delicate fabrics
Reduced Reduces creasing and extends the anti-creasing phase once the program has ended.
Ironing
1
Preparing for
installation, see Page 8
Never start the dryer if it is damaged!
Inspecting the
Inform your after-sales service.
dryer
Make sure your hands are dry. Connecting the
Hold the plug only.
mains plug
Sorting and loading laundry
Remove all items from pockets.
Check for cigarette lighters.
The drum must be empty prior to loading.
See programme overview on page 7.
See also separate instructions for "Woollens basket"
(depending on model)
Selecting and adjusting the programme
1
Select the drying programme ...
2
... and adapt to individual requirements
Programme selector
All buttons are sensitive and only
need to be touched lightly.
3
Press the Start/Stop button
Only operate the dryer with
the fluff filter inserted!
End of programme in 1*-24 hours (Press button several times if required)
(*depending on the selected programme, e.g. duration 1:54h 2h. Can always be selected to the
next full hour.)
page 4/6.
that require a longer drying time; e.g. for polyacrylics, polyamide, elastane or acetate.
2
Drying
Emptying condensation
Empty container after each drying operation!
1. Pull out condensation container keeping it horizontal.
2. Pour out condensation.
3. Always push container in fully until it clicks into place.
If Container flashes in the display panel What to do if..., Page 10.
Condensation container
Cleaning the fluff filter
Control panel
Drum interior light
Clean the fluff filter after each drying operation.
(depending on model)
1. Open the door, remove fluff from door/door area.
2. Pull out and fold open the fluff filter.
3. Remove the fluff (by wiping the filter with your hand).
If the fluff filter is very dirty or blocked, rinse with warm water and dry
thoroughly.
4. Close and reinsert the fluff filter.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
The automatic anti-crease function causes the drum to move at specific intervals, the washing remains
loose and fluffy for an hour (two hours if the additional Reduced Ironing
depending on model).
Maintenance Air inlet
flap
Programme end
Fluff filter once lights up in the display.
Drum
Interrupt programme
removing or adding laundry.
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The programme selected must then be resumed and completed.
Drying Never switch the dryer off before the drying process has ended.
Drum and door may be hot!
1. Open door, the drying process is interrupted.
2. Load or remove laundry and close door.
3. If required, select a new programme and additional functions.
4. Press the Start/Stop button. The remaining time is updated after a few minutes.
3
Information on laundry ...
Labelling of fabrics
Follow the manufacturer's care information.
Drying at normal temperature.
Drying at low temperature also select Low Heat .
Do not machine dry.
Observe safety instructions without fail Page 11!
Do not tumble-dry the following fabrics for example:
– Impermeable fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk or curtains made from synthetic material) they may crease
– Laundry contaminated with oil.
Drying tips
– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand
towel).
– Close zips, hooks and eyelets, and button up covers.
Tie fabric belts, apron strings, etc. together
– Do not over-dry easy-care laundry risk of creasing!
Allow laundry to finish drying in the air.
– Do not dry woolens in the dryer, only use to freshen them up Page 7, Woollens finish
Programme (depending on model).
– Do not iron laundry immediately after drying, fold items up and leave for a while
function is also selected- remaining moisture will then be distributed evenly.
– Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried
do not use the Very Dry programme.
– Starched laundry is not always suitable for dryers starch leaves behind a coating that
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried.
– Use the timer programme for small loads this improves the drying result.
Environmental protection/energy-saving tips
– Before drying, spin the laundry thoroughly in the washing machine the higher the spin
speed the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Put in, but do not exceed, the maximum recommended quantity of laundry
programme overview Page 7.
– Make sure the room is well ventilated during drying.
– Do not obstruct or seal up the air inlet.
– Keep the air cooler clean page 6 "Care and cleaning".
4
Only when switched off!
Care and cleaning
Dryer housing, control panel, air cooler, moisture sensors
– Wipe with a soft, damp cloth.
– Do not use harsh cleaning agents and solvents.
– Remove detergent and cleaning agent residue immediately.
Clean the air cooler 5 - 6 times a year
or if Filter flashes after cleaning the fluff filter.
Air cooler
– Allow the dryer to cool.
– Residual water may leak out, so place an absorbent towel
underneath the maintenance door.
1. Unlock the maintenance door.
2. Open the maintenance door fully.
3. Turn both locking levers towards each another.
4. Pull out the air cooler.
Do not damage the air cooler.
the
Clean with warm water only. Do not use any hard or sharp-edged
objects.
5. Clean the air cooler thoroughly,
Allow to drip dry.
6. Clean the seals.
7. Re-insert the air cooler,
with the handle facing down.
8. Turn back both locking levers.
9. Close the maintenance door until the lock clicks into place.
Moisture sensors
The dryer is fitted with stainless steel moisture sensors. The sensors
measure the level of moisture in the laundry. After a long period of
operation, a fine layer of limescale may form on the sensors.
1. Open the door and clean the moisture sensors with a damp sponge
which has a rough surface.
Do not use steel wool or abrasive materials.
5 6