Cleaning water inlet
strainers
Cleaning the strainer at the
water tap
Cleaning the strainer on the
washer-dryer
47
This is necessary if very little or no water flows into the
washer-dryer.
First, reduce the water pressure in the inlet hose:
Turn off the tap.
■
Turn the programme selector to any programme
■
(except Spin Í/ Drain
Touch the Start/Pause P button, and allow the
■
programme to run for approx. 40 seconds.
Turn the programme selector to Off.
■
Disconnect the hose from the water tap.
■
Rinse the strainer under flowing water.
■
Connect the hose.
■
Disconnect the hose from the back of the
■
washer-dryer.
Pull out the strainer and rinse under running water.
■
Insert the strainer and reconnect the hose.
■
Turn on the water tap and check whether water is
■
still discharged. If water is leaking, check that the
filter is correctly seated.
Turn off the tap.
■
).