Complete The Installation; Care And Cleaning - Kohler PureWarmth K-10349-96 Installation And Care Manual

4. Complete the Installation

WARNING: Risk of electric shock, fire, or personal injury.
Connect only to a nominal 120 VAC, 60 Hz circuit protected
by a minimum 15 A Ground-Fault Circuit-Interrupter (GFCI)
or Residual Current Device (RCD).
If not already installed, install an electrical outlet within 4' (1219
mm) of the toilet.
Thread the power supply cord onto the toilet seat cord. Tighten
the barrel.
Plug the power supply into the electrical outlet.
To begin using this product, refer to the quick start guide.

Care and Cleaning

For best results, keep the following in mind when caring for your
KOHLER product:
IMPORTANT! Do not immerse product in water.
• Always test your cleaning solution on an inconspicuous area
before applying to the entire surface.
• Use a soft, dampened sponge or cloth to wipe surfaces clean.
Remove the cleaner quickly after applying. Rinse and dry any
overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
Kohler Co. 7 1347697-2-A