LG C12LHR Owner's Manual page 4

Safety Precautions
Indoor/outdoor wiring connections must be
secured tightly and the cable should be routed
properly so that there is no force pulling the
cable from the connection terminals.
• Improper or loose connections can cause
heat generation or fire.
Be sure to check the refrigerant to the
used. Please read the label on the
product.
• Incorrect refrigerant used can prevent the
normal operation of the unit.
Do not place a heater or other heating
appliances near the power cable.
• There is risk of fire and electric shock.
Do not use the product in a tightly
closed space for a long time. Perform
ventilation regularly.
• Oxygen deficiency could occur and hence
harm your health.
Ventilate the product room from time to
time when operating it together with a
stove, or heating element etc.
• Oxygen deficiency can occur and hence
harm your health.
Take care to ensure that nobody especially kids
could step on or fall onto the outdoor unit.
• This could result in personal injury and
product damage.
Do not plug or unplug the power supply
plug to turn the unit ON/OFF .
• There is risk of fire or electric shock.
Two or more people must lift and
transport the product.
• Avoid personal injury.
Keep level even when installing the
product.
• To avoid vibration or noise.
4 Room Air Conditioner
Safely dispose off the packing materials. Like
screws, nails, batteries, broken things etc
after installation or svc and then tear away
and thraw away the plastic packaging bags.
• Children may play with them and cause
injury.
Don't use a power cord, a plug or a
loose socket which is damaged.
• Otherwise it may cause a fire or electrical
shock.
Do not allow water to run into electric parts.
Install the unit away from water sources.
• There is risk of fire, failure of the product, or
electric shock.
Do not open the front grille of the product
during operation. (Do not touch the
electrostatic filter, if the unit is so equipped.)
• There is risk of physical injury, electric
shock, or product failure.
Turn the main power off and unplug the
unit when cleaning or repairing the
product.
• There is risk of electric shock.
Take care to ensure that power cable could not
be pulled out or damaged during operation.
• There is risk of fire or electric shock.
When flammable gas leaks, turn off the
gas and open a window for ventilation
before turn the product on.
• Do not use the telephone or turn switches
on or off. There is risk of explosion or fire.
Do not install the product where it will be
exposed to sea wind (salt spray) directly.
• It may cause corrosion on the product.
Do not install the product where the noise or
hot air from the outdoor unit could damage
or disturb the neighborhoods.
• It may cause a problem for your neighbors
and hence dispute.
Make sure to check that the power cable
plug is not dirty, loose or broken and
then only insert the plug completely.
• Dirty, loose or broken power plug can
cause electric shock or fire.
Do not touch , operate, or repair the
product with wet hands. Hold the plug
by hand when taking out
• There is risk of electric shock or fire.
Do not store or use or even allow flammable
gas or combustibles near the product.
• There is risk of fire.
If strange sounds, smell or smoke comes
from product.Immediately turn the
breaker off or disconnect the power
supply cable.
• There is risk of electric shock or fire.
When the product is not to be used for
a long time, disconnect the power
supply plug or turn off the breaker.
• There is risk of product damage or failure, or
unintended operation.
Do not place ANYTHING on the power
cable.
• There is risk of fire or electric shock.
For inner cleaning, contact an
Authorized Service Center or a dealer.
Do not use harsh detergent that causes
corrosion or damage on the unit.
• Harsh detergent may also cause failure of
product, fire, or electronic shock.
Install the drain hose to ensure that the
condensed water is drained away properly.
• A bad connection may cause water leakage.
Always check for gas (refrigerant)
leakage after installation or repair of
product.
• Low refrigerant levels may cause failure of
product.