Menu Option
Warping
Zoom
Digital Lens Shift
OverScan
Description
The function is to configure the geometric distortion of the
projector's images when the images are projected onto
screens which have a kind of uneven surface such as a cylinder,
a spherical shape, etc.
Enable
Keystone and Corner Adj. will not be available when Warping is
enabled.
Control Method
Allows you to select a preferred control method for warping
adjustment.
Warping Adj.
This function is available when On is selected in the Warping
> Enable menu and OSD is selected in the Warping >
Control Method menu.
1.
Use
/ / /
adjust.
2. Press Enter to enter adjustment mode.
3. Use
/ / /
4. Press Menu to exit adjustment mode.
5. Repeat step 1 to 4 to ajdust another point until you are
satisfied with the projected image.
6. Press Menu/Exit to exit the function.
Reset
Returns settings in the
values.
Magnifies the projected image and allows you to navigate the
image.
Digital lens shift is a tool that assists in properly aligning the
projector's image with the projector screen when digital zoom
adjusted less than 1.0x, making it far easier to correctly mount
or position a projector for optimal installation. Projectors with
digital lens shift have the ability to move the projected image
up, down, left and right to easily accommodate placement/
installation at a variety of heights & widths.
You can adjust the vertical or horizontal lens shift by +/- 50
pixels.
Adjusts the overscan rate from 0 to 5.
NOTE:
This function is only available when a Composite Video or
HDMI input signal is selected.
to move the cursor to the point you wish to
to shift the point by x and y coordinates.
Warping
menu to the factory preset
44