Changing The Intensity Level Of Stimulation - Einstein E-Collar 800TS Owner's Manual

CHANGING THE INTENSITY LEVEL
It is highly recommended that the user practices changing levels
and modes before putting the collar receiver on the dog.
Setting the correct stimulation level for your dog is very important.
To set your "conditioning" stimulation level, put the collar receiver
(see page 25 for proper fitting technique) on your dog. Let him/
her get used to the collar receiver for a couple of hours.
While watching your dog, turn the level to "0" and press the
continuous stimulation button. Slowly turn the stimulation up at
a rate of approximately 2-3 levels per second. When your dog
first perceives the stimulation, usually between 5 and 30, release
the button. This is your "conditioning" stimulation level. You may
need to increase the "conditioning" level a few levels to get your
dog to respond, some dogs are more stubborn and need more
stimulation. The 'corrective" level is typically 10 to 30 levels
higher than the "conditioning level.
OF STIMULATION
Rotating clockwise increases the
stimulation level and conversely,
rotating counter-clockwise lowers
the stimulation level.
Einstein Owner's Manual 800TS / 1200TS
17