Water Piping - Mixing Valve Usage - A.O. Smith 197835-001 Instruction Manual

water pIpInG - MIXInG valve usaGe

* the side recirculation loop connections may not be used as the primary water inlet and outlet connections. for your convenience, plugs are installed
in these fittings at the factory. Remove these plugs if needed for your specific installation. Otherwise (as with all connections) check for leaks while
filling the tank with water and after completing the installation.
This appliance has been design certified as complying with
American National Standard/CSA Standard for water heaters and
is considered suitable for:
Water (Potable) Heating and Space Heating: All models are
considered suitable for water (potable) heating and space heating.
FIGURE 2.
HOTTER WATER CAN SCALD:
Water heaters are intended to produce hot water. Water heated
to a temperature which will satisfy space heating, clothes
washing, dish washing, and other sanitizing needs can scald
and permanently injure you upon contact. Some people are more
likely to be permanently injured by hot water than others. These
include the elderly, children, and the physically or developmentally
disabled. If anyone using hot water from this heater fits into one
of these groups or if there is a local code or state law requiring
a certain temperature water at the hot water tap, then you must
take special precautions. In addition to using the lowest possible
temperature setting that satisfies your hot water needs, a means
such as a Mixing Valve, should be used at the hot water taps
used by these people or at the water heater, see Figure 2. Mixing
valves are available at plumbing supply or hardware stores.
Consult a Qualified Installer or Service Agency. Follow mixing
valve manufacturer's instructions for installation of the valves.
Before changing the factory setting on the thermostat, read the
"Temperature Regulation" section in this manual.
9