Toyotomi TDN/TDG-A28VR5 User Manual page 12

Introduction for buttons on remote controller
HEALTH SAVE:
7
Pressing SAVE part of this button,
mode. Press SAVE part of the button again to cancel SAVE function. During SAVE
operation, the temperature and fan speed is not adjustable.
8
Press button to start or stop left & right swing function.The remote controller defaults to
simple swing condition.
P e r s s + b t u o t n n a
and static swing;
n I s a t c i t s w n i g o c
below:
(Optional for some models)
9 BLOW:
Pressing BLOW button in COOL or DRY mode,the icon "BLOW" is displayed and the
indoor fan will continue operation for 2 minutes in order to dry the indoor unit even though
After energization, BLOW OFF is defaulted. BLOW is not available in AUTO, FAN and
HEAT mode.
10
TEMP:
Press this button, you can see indoor set temperature, indoor ambient temperature
on indoor unit's display. The setting on remote controller is selected circularly as below:
When selecting " " with remote controller or no display, temperature indicator on indoor unit
displays set temperature; When selecting
indoor unit displays indoor ambient temperature; 3s later or within 3s it
receives other remote control signal that will return to display the setting temperature.
Caution:
This model hasn't outdoor ambient temperature display function. While remote controller can
operate " "and indoor unit displays set temperature.
It's defaulted to display set temperature when turning on the unit.
for the models with temperature indicator on indoor unit.
TIMER:
11
Press TIMER button at unit ON to set TIMER OFF; HOUR OFF blinks. Press TIMER
button at unit OFF to set TIMER ON; HOUR ON blinks. In this case, pressing + or -
button changes time setting. Holding downeither button rapidly changes time setting
ON/OFF stops blinking. If there is not any operation of button within 5 seconds during
HOUR ON/OFF blinking,TIMER setting will be cancelled.
TURBO:
12
Press this button to activate / deactivate the Turbo function which enables the unit to
reach the preset temperature in shortest time. In COOL mode, the unit will blow strong
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed. (This function is not applicable for some models).
is displayed and the unit goes into SAVE operation
d button at the same time at unit OFF to switch between simple swing
blinks for 2 seconds.
n d t i o i n p , e r s s n i g b t u o t , n h t
during swing operation,the louver will stop at present position.
the unit.
with remote controller, temperature indicator on
12
HEALTH function.
e s w n i g n a g e l f o e l t f & r g i
rm setting; HOUR
t h o l v u r e h c n a g s e s a
GB