Table of Contents
Advertisement
MAINTENANCE (continued)
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
•
Clean and dry the area to be repaired thoroughly.
•
Remove the patch backing paper and press patch fi rmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
The ambient temperatures of air have an effect on the spa tub internal pressure. Air inside of the
spa tub may expand and contract with varying temperature leading to reduce pressure inside
of the spa tub. If this occurs, simply use the provided pressure gauge to check the internal air
pressure and add more air if necessary.
Drain and clean the spa following the "Spa Tub Drainage" and "Spa Tub Cleaning" sections.
1.
Reverse set up instructions to defl ate and disassemble the spa tub, spa control unit and spa cover air
2.
bladder.
Spa Tub defl ation with the Electric Air Pump (see drawing 17).
3.
a) Attach the infl ation pump adaptor (24) to the defl ation port.
b) Connect the infl ation hose (7) to the infl ation pump adaptor.
c) Insert the other end of the infl ation hose (7) into the valve and turn to
the right to lock it in position. Switch on the electric air pump to defl ate.
Make sure all the spa components and accessories are thoroughly clean
4.
and dry before storage. Air-dry the spa tub in the sun for an hour before
folding.
Fold the spa tub loosely and avoid any sharp corners to prevent damage
5.
or leakage to the spa tub liner.
Prepare additional new cartridges for next time use.
6.
Store the spa tub and accessories in a dry, temperature controlled,
7.
between 0º – 40ºC (32º – 104ºF), storage location.
The original packing can be used for storage.
8.
S AVE THESE INSTRUCTIONS
(297IO) SPA (JET + HARD WATER) ENGLISH 7.5" X 10.3" PANTONE 295U 07/26/2016
IMPORTANT
STORAGE
297
English
A
17
7
24
9
Page 19
Advertisement
Table of Contents
