Set the remote control ID when you want to use this
remote control on several different Displays.
16
English
Press the [ID] button. The red LED will blink twice.
1.
Press the [ID SET] button for more than one second
to enter the ID Mode. The red LED will come on.
Pressing the [ID SET] button again will exit the ID
Mode. The red LED will go off.
Press digits [0] ~ [9] to select the Display you want
to control.
For example: press [0] and [1] for Display No. 1,
press [1] and [1] for Display No. 11.
The numbers available are from [01] ~ [255].
2.
The ID Mode will terminate if no selection is made
within 10 seconds.
3.
If a button other than a digit is pressed by mistake,
wait for one second after the red LED goes off and
comes on again. Now choose the correct digits.
4.
Press [ID ENTER] to confirm. The red LED will blink
twice and then go off.
Notes
●
Press the [NORMAL] button. The green LED blinks
twice, to indicate the Display is in normal operation
mode.
●
It is necessary to set up the Monitor ID for each
Display before selecting its ID number.