RIDGID 50333 Manual page 6

SP6961 1250RV0 A.qxp_SP6961 6/8/15 9:20 AM Page 6
Vacuum Assembly (Continued)
Installing Accessory Holder
1. Attach the flexible end of the
accessory holder at the top of the Vac
drum. The non-elastic end should be
located at the bottom of the Vac drum.
2. Install accessory holder as shown with
the 4 screws included.
3. Tighten screws so that there is a small
clearance between the screw head
and the grommet on the accessory
holder.
Note: Leave a clearance between the
screw head and grommet. If no
clearance, the accessory holder will twist
with the screws.
6
Flexible
End
Accessory
Holder
Accessory
Holder
Screw (4)
Non-Elastic
End