Starting The Programme; Cancelling The Programme; Salt Indicator ( ); Rinse Aid Indicator ( ) - Blomberg LDVS2284 Instruction Manual

Operating the product
To cancel the Time Delay function
1. Press and hold the Programme
Selection / Programme Cancel keys for
3 seconds.
2. '3', '2', '1' will appear on the display
while you keep Programme Selection
/ Programme Cancel keys pressed.
Time Delay indicator will turn off at the
end of the cancellation process and
delaying process is cancelled.
C
You can select and start a
new programme following
the cancellation of Time Delay
function.
C
Time Delay function cannot be
set after the programme starts.

Starting the programme

Close the door of your machine to start
it after selecting the programme and
auxiliary functions.
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Washing time can
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the
dishes.
C
Pay attention not to open the
door of the machine when it is
running. There may be a rush of
vapour when you open the door
of your machine; be careful.
/37 EN
26
C
The machine will remain silent
in pause mode for some time
in order to remove the water
from the machine and on the
dishes completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.

Cancelling the programme

Press and hold the Programme Selection
/ Programme Cancel keys for 3 seconds.
Release the key as the Start/Cancel
indicator starts flashing.
Once you close the door of your machine,
draining is completed in 2 minutes
and the machine gives an audible warning
when it is completed.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.

Salt indicator ( )

Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Rinse Aid indicator ( )

Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
Dishwasher / Instruction Manual