Dell 5WC10 Installation And Service Manual page 47

Option Description
Dead Line LLC Enables or disables the Dead Line LLC Alloc. This option is set to Enabled by default. You can enable this
Alloc option to enter the dead lines in LLC or disable the option to not enter the dead lines in LLC.
Directory AtoS Enables or disables the Directory AtoS. AtoS optimization reduces remote read latencies for repeat read
accesses without intervening writes. This option is set to Disabled by default.
Logical Enables you to improve the energy efficiency of a system. It uses the operating system core parking
Processor Idling algorithm and parks some of the logical processors in the system which in turn allows the corresponding
processor cores to transition into a lower power idle state. This option can only be enabled if the
operating system supports it. It is set to Disabled by default.
Intel SST-BF Enable Intel SST-BF. This option is displayed if Performance Per Watt (operating system) or Custom
(when OSPM is enabled) system profiles are selected. It is set to Disabled by default.
Intel SST-CP Enable Intel SST-CP. This option is displayed if Performance Per Watt (operating system) or Custom
(when OSPM is enabled) system profiles are selected. It is set to Disabled by default.
Configurable TDP Enables you to configure the TDP level. The available options are Nominal, Level 1, and Level 2. This
option is set to Nominal by default.
x2APIC Mode Enables or disables the x2APIC mode. This option is set to Enabled by default.
Number of Cores Controls the number of enabled cores in each processor. This option is set to All by default.
per Processor
Processor Core Specifies the maximum core frequency of the processor.
Speed
Processor Bus Displays the bus speed of the processor.
Speed
Processor n
The following settings are displayed for each processor that is installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores Specifies the number of cores per processor.
Maximum
Memory Capacity
Microcode
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on
your system.
NOTE: This option is only available on certain stock keeping units (SKUs) of the processors.
NOTE: Depending on the number of processors, there might be up to two processors listed.
Description
Specifies the family, model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the maximum memory capacity per processor.
Specifies the microcode.
Pre-operating system management applications 47