Table of Contents
Advertisement
Figure 113. Installing the system board
4. Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1. Replace the following:
a.
Trusted Platform Module (TPM)
b.
Memory modules
c.
Processors and heat sink modules
d.
Internal USB key
e.
vFlash/IDSDM module
f.
Integrated storage controller card
g.
Expansion
cards, if installed
h.
Cooling fan
assembly, if applicable
i.
Expansion card holder
j.
GPU card holder
k.
Air shroud
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable
securing bracket.
3. Follow the procedure listed in
4. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the
Easy Restore
section.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the
Restoring the Service Tag using Easy Restore
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the
section.
5. Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide , at www.dell.com/poweredgemanuals.
After working inside your system
section.
on page 67.
Upgrading the Trusted Platform Module
Installing and removing system components
Restoring the Service Tag using
155
Advertisement
Table of Contents
