Yamaha XT250W Owner's Manual page 70

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
NOTE:
4 The drive chain does not need to be
disassembled in order to remove and
install the wheel.
5
8. Pull the wheel axle out, and then
remove the wheel.
6
7
To install the rear wheel
1. Insert the wheel axle from the
left-hand side.
8
9
1. Retainer
NOTE:
Make sure that the drive chain adjust-
ing plates are installed with the
punched sides facing to the outside
and that the slot in the brake shoe plate
fits over the retainer on the swingarm.
EAU25791
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-22.)
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
4. Tighten the axle nut to the speci-
fied torque.
6-35
Tightening torque:
Axle nut:
1
85 Nm (8.5 m·kgf, 62 ft·lbf)
5. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
6. Adjust the brake pedal free play.
(See page 6-18.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
7. Install the engine guard by install-
ing the bolt.
EWA10660