Table of Contents
Advertisement
2.
Disconnect the display panel cable (2) from the system board.
CAUTION:
support the display assembly might result in damage to the display assembly and other computer
components.
3.
Remove the three screws (1) that secure the display assembly to the computer.
4.
Remove the BrightView display assembly (2).
5.
To replace the display bezel or any of the display assembly internal components, remove the
following:
●
Two rubber screw covers on the display bezel bottom edge (1).
●
Two screws (2). The display rubber screw covers are included in the Display Rubber Kit,
spare part number 603659–001.
66
Chapter 4 Removal and replacement procedures
Support the display assembly when removing the following screws. Failure to
ENWW
Hide quick links:
Advertisement
Table of Contents
