Connecting Ac Power To The Switch; Installing The Ac Power Cord Retainer - D-Link DXS-1210 Series Hardware Installation Manual

DXS-1210 Series 10 Gigabit Ethernet Smart Managed Switch Hardware Installation Guide

Connecting AC Power to the Switch

To install the AC power supply to the Switch correctly, plug one end of the AC power cord into the AC power socket of
the Switch and the other end of the AC power cord into the local AC power source outlet. There is no power
switch/button on the Switch. The system will power on automatically.
After the system is powered on, the Power LED will blink green to indicate that the system is booting up. In the event
of a power failure, just as a precaution, unplug the power cord from the Switch. After the power returned, plug the
power cord back into the power socket of the Switch.

Installing the AC Power Cord Retainer

To prevent accidental removal of the AC power cord, it is recommended to install the AC Power Cord Retainer Set
together with the AC power cord. The AC Power Cord Retainer Set is included in the package contents.
With the rough side facing down, insert the tie wrap into the hole below the power socket.
Figure 3-6 Insert Tie Wrap into the Switch
10