Features; Assembly; Operation - RIDGID R87208 Operator's Manual

FEATURES

PRODUCT SPECIFICATIONS
No Load Speed:
Auto Mode (A) .........................0-2,800/min. (RPM)
Low (1) .......................................0-850/min. (RPM)
Medium (2) ..............................0-2,100/min. (RPM)
High (3)....................................0-2,800/min. (RPM)

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING :
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
Anvil ........................................................................... 1/2 in.
Impacts per minute .........................................0-3,800/min
Max Fastening Torque. ........................................200 ft.-lbs
Max Breakaway Torque .......................................225 ft.-lbs
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Driving nuts and bolts using an impact socket
INSTALLING/REMOVING BELT HOOK
See Figure 1, page 9.
The belt hook may be installed on either side of the housing.
 Align hole in belt hook with hole in the housing.
 Install screw to secure belt hook in place.
 To uninstall, remove screw then remove belt hook.
VARIABLE SPEED SWITCH TRIGGER
See Figure 2, page 9.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the anvil to come
to a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
6 - English