Table of Contents
Advertisement
WARNING: Accessible parts may be very hot. Keep young children away from the hot appliance at all
times (even while cooling down!). It is recommended that protective gloves (e.g. oven gloves) be used
when handling particularly hot components.
CLEANING AND CARE
CAUTION:
All cleaning and maintenance should be carried out when the oven is cool and with the fuel
supply turned OFF at the gas cylinder.
CLEANING
"Burning off" the oven after every use (for approx 15 minutes) will keep excessive food residue to a
minimum.
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on
stubborn stains, then rinse with water.
If the inside surface of the oven lid has the appearance of pealing paint, baked on grease build-up has
turned to carbon and is flaking off. Clean thoroughly with strong hot soapy water solution. Rinse with
water and allow to completely dry. NEVER USE OVEN CLEANER.
INTERIOR OF OVEN BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse
with water and allow to dry.
CLEANING THE BURNER ASSEMBLY
Turn the gas OFF at the control knob and disconnect the cylinder.
Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall
the burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the
burner inlet (venturi).
IGNITER TIP CLEANING:
If lighting the burners is difficult you may need to clean and adjust the igniter tip located near the burner
orifice. (FIG. 12). To ensure that the igniter lights properly, clean off any cooking residue from igniter tip
and burner. Use a very fine grit sand paper to clean igniter tip an edge of burner. Igniter tip should be
4–6 mm away from burner edge. (FIG. 13)This is the ideal distance for most effective ignition.
Burner
FIG. 12
Igniter tip
Igniter tip
Burner
FIG. 13
Advertisement
Table of Contents
