Table of Contents
Advertisement
Clean burner holes with a heavy-duty pipe cleaner/wire brush.
Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is
replaced it must be secured to the appliance and regulator connections with hose clips. Disconnect the
regulator from the cylinder (according to the directions supplied with the regulator) when the oven is not in
use.
The oven must be used in a well ventilated area. Do not obstruct the flow of combustion air to the burner
when the oven is in use. ONLY USE THIS OVEN OUTDOORS.
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure
then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified, do not attempt to cure leakage but consult your gas dealer.
Lighting Instructions for barbecue
Open the hood of the oven before attempting to light the burners and remove the 3 stainless steel
1.
trays.
2.
Turn all the control knobs clockwise to "OFF" position.
3.
Connect the regulator to the gas bottle. Turn the gas supply "ON" at the regulator. Check with the use
of soapy water for any gas leakage between the bottle and the regulator.
4.
On one of the two burners, push in the control knob and turn it anti-clockwise to the "HIGH" position,
at the same time hold in the ignition button (a clicking sound will be heard) this will light the pilot and
the burner. Keep pressing in the knob for a further 15 seconds observe if the burner has lit. If not,
repeat this process. Then repeat for the second burner if required.
5.
If the burner has not lit after retrying wait 5 minutes and repeat step 4.
6.
Adjust the heat by turning the knob to the High/Low position.
7.
If the burner does not light with the ignition spark it can be lit manually with a long reach lighter from
the inside. Consult your gas dealer to rectify the ignition.
8.
To turn the burner 'OFF,' turn the control knob clockwise to the 'OFF' position. If you wish to turn the
complete oven 'OFF' turn the cylinder valve or regulator switch to the 'OFF' position and then turn the
control knob on the appliance clockwise to the 'OFF' position on both burners.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve
off. Wait five minutes before attempting to relight with ignition sequence.
Before cooking for the first time, operate the oven for about 15 minutes with the lid closed and the gas
turned on HIGH. This will "heat clean" the internal parts and dissipate odour from the painted finish.
Clean your oven after each USE. DO NOT use abrasive or flammable cleaners, as it will damage the parts
of the product and may start a fire. Clean in hot soapy water. BUT ensure you protect the motor from water
ingression.
BEFORE USE CHECK FOR LEAKS
Advertisement
Table of Contents
