Frigidaire CGIF3061NFD Use & Care Manual page 27

Probe (cont'd)
Choosing a setting for how the oven will operate
once the probe reaches the target temperature
Your oven is factory preset to automatically stop cooking
and start the keep warm feature once the probe sensor
reaches the set target temperature. This setting may be
changed to continue cooking if desired.
IMPORTANT
Setting the option for how the oven will heat once the
probe reaches the target temperature must be done
when the oven is inactive. The probe is not required to
be connected to the probe receptacle when setting this
option.
To set the oven to continue cooking after reaching
the target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until the "Continu"
message appears (Fig. 1) then press
To set the oven to automatically stop cooking and
start keep warm once reaching target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until "CAnCEL"
message appears (Fig. 2) then press
to accept.
Fig. 1
to accept.
Fig. 2
SETTING OVEN CONTROLS
NOTES
• During the cooking process, the internal food
temperature will display by default. To review the
target temperature, press the
6 seconds the display will return to the internal food
temperature.
• To assure temperature accuracy, do not remove the
probe from the food or receptacle until the desired
internal temperature is met.
• If the probe feature is active but the probe is removed
from the receptacle, the probe feature will cancel but
the oven will continue to cook.
• If the probe is active and the probe is removed from
the food, the probe feature will remain active. The
displayed internal food temperature may no longer
be reliable. This may eventually cause a "Probe Too
Hot" message.
• The oven will automatically turn OFF if the probe
sensor reaches 300°F (149°C) or more.
• The probe feature cannot be set with broil,
convection broil, or self-clean.
• To change the target temperature while cooking,
press the keypad once. Use the numeric keypad
to change the target temperature. Press the start key
to accept any change.
key once. After
27