Compaq Evo N600c Maintenance And Service Manual page 101

5. Remove the black M1 × 6 Phillips screw 1 and silver
M2 × 6.5 Phillips screw 2 that secure the fan to the system
board (Figure 5-20).
6. While holding the system board above the work surface, push
the left side of the fan up 3 from the bottom of the system
board.
7. When the left edge of the fan has cleared the system board,
slide the fan to the left 4 and out of the heat sink.
Figure 5-20. Removing the Fan
8. Remove the fan.
Reverse the above procedure to replace the fan.
Maintenance and Service Guide
Removal and Replacement Procedures
5–29