Panasonic PT-VX430 Operating Instructions Manual page 17

The angle that can be corrected through [POSITION] menu → [SCREEN ADJUSTMENT] → [KEYSTONE] is
within ±35°. If the vertical tilt of the projector with respect to the screen surface exceeds 35°, vertical trapezoidal
distortion may not be fully corrected.
Within 40°
Within 40°
rCautions when setting the projectors
f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f If you want to install the projector with a method other than desk/floor setup using the adjustable feet or ceiling
mount with the ceiling mount accessories, use the three screw holes for ceiling mounting (as shown below) to fix
the projector.
(Screw: M4; Depth of the screw hole: 8 mm (5/16"); Torque: M4 1.25 ± 0.2 N·m)
In addition, always keep a gap of more than 20 mm (25/32") between the bottom of the projector and installation
surface.
Make sure that there is no clearance between the screw holes for ceiling mount on the projector bottom and the
installation surface by inserting spacers (metallic) of at least 20 mm (25/32") between them.
The positions of adjustable feet and the
screw holes for ceiling mounting
f Do not stack the projectors.
f Do not use the projector supporting it by the top.
f Do not block the ventilation ports (intake and exhaust) of the projector.
f Avoid heating and cooling air from the air conditioning system directly blow to the ventilation ports (intake and
exhaust) of the projector.
Over 500 mm
(19-11/16")
Over 500 mm
(19-11/16")
Chapter 1 Preparation - Precautions for use
Within 15°
Within 15°
Adjustable feet
Air intake port
(bottom)
Screw holes for
ceiling mounting
(M4)
Over 1 000 mm
(39-3/8")
Over 7 mm
(9/32")
Installation surface
f Make sure the air flow into the air intake
port (bottom), failure to do so may cause the
projector cannot work.
Over 20 mm
"
(25/32 )
Over 200 mm
(7-7/8")
ENGLISH - 17