Table of Contents
Advertisement
Before Operation-VCR part
Tuning in a video channel on your TV
Notes
The output frequency of this video recorder
(VCR) is set at UHF channel 36. If channel 36
is already used by another TV station, or if the
picture is distorted, you can change the
transmitter channel of your VCR. Stages 5 ~ 8
will show you how to change the output
frequency of your VCR.
Your TV receives signals from the video
recorder (VCR) like another TV station. You
have to select a channel number on your TV
and tune it in so that you may watch video
tapes. If you have used AUDIO and VIDEO
cables then your TV should already have a
dedicated video channel built into it, usually
called AV.
1. Make sure that you have correctly installed your
VCR as described earlier in this book.
Press POWER to turn on your VCR.
Turn on your TV.
2. Insert a pre-recorded video tape into your VCR
and press PLAY on the remote control.
Select a TV channel number on which you wish to
watch video's.
Don't worry if you don't have a video-tape to play
at this stage! If you switch your VCR on and con-
tinue stages 3 ~ 4, instead of seeing video play-
back tune your TV until you see a bright blue
screen.
3. Tune this channel until the video picture is sharp
and the sound is clear.
If you have used a AUDIO and VIDEO cables you
will not have to tune your TV, simply select the AV
channel. The AV channel is already pre-tuned for
optimum video playback on your TV.
4. Store this channel on your TV.
You will need to look at the TV instruction book if
you do not know how to do this.
5. Only carry out stages 5 ~ 8 if you cannot
obtain clear video playback as described in
stages 1 ~ 4. Select a TV channel number on
which you wish to watch video's.
Make sure that your VCR is in standby pressing
POWER on the remote control (only the clock will
be displayed).
16
6. Press PROG. + or - on the front of your VCR for
more than 4 seconds.
RF36 will appear in the display window.
The following picture will be displayed on the TV
screen.
RF CHANNEL
P SET
R
7. Press PROG. + or - to select another video channel.
You may select any channel number between 22
and 68.
You can also set it to "OFF" if there is any interfer-
ence when your TV is connected to the VCR with a
RCA lead.
8. Select a TV channel number on which you wish to
watch video's.
Press
STANDBY/ON on the front of your VCR
when you have finished.
Tune this channel so that a bright blue screen
appears.
Store this channel on your TV.
Note
Make sure that you have correctly installed your
VCR and successfully tuned in a dedicated
video channel on your TV. If you do not tune in a
dedicated video channel on your TV you will be
unable to view and record video tapes!
Using your VCR for the very first
time
Following picture will display on the TV screen
when you have just connected your video
recorder for the very first time.
To make tuning TV stations, please follow stages
3 to 4 as shown "ACMS" (see p.18).
ACMS
Pr-12
ACMS
36
i
OK i
Advertisement
Table of Contents
