Table of Contents
Advertisement
Rear
Safety cover fixing hole
(7 positions)
The fixing holes for installing the
safety cover (sold separately) that is
used for portrait installation.
Intake vent
Takes in outside air to cool the unit.
There are air intake and ventilation
holes on the bottom.
(→ page vii, 141)
Security Bar
Attach an anti-theft device.
The security bar accepts security
wires or chains up to 0.18 inch/4.6
mm in diameter.
Adjustable Tilt Foot
(→ page 22)
* This security slot supports the MicroSaver
Security System.
®
6
1. Introduction
Stacking holder fixing position
(3 positions)
For stacking up the projectors, fas-
ten up the stacking holders supplied
with this projector.
Remote Sensor (located on the
front and the rear)
(→ page 11)
Terminals
(→ page 8)
AC IN terminal
Connect the supplied power cord's
three-pin plug here, and plug the
other end into an active wall outlet.
(→ page 13)
Main power switch
While AC power is being supplied,
set the main power switch to ON
position (|), then your projector will
enter a standby state.
Built-in Security Slot (
)*
Advertisement
Table of Contents
