Power Button And Reset Button Behavior - QNAP TS-231+ Hardware User Manual

Chapter 2.

Power Button and Reset Button Behavior

Power button: Press to turn on or turn off.

System
All models
Reset button: Press to reset the system settings.

System
All models
Basic system reset (3 sec)
Press the reset button for 3 seconds, a beep sound will be heard. The following settings are
reset to default:
System administration password: admin

TCP/IP configuration: Obtain IP address settings automatically via DHCP

TCP/IP configuration: Disable Jumbo Frame

TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port

trunking mode will be reset to "Active Backup (Failover)".
System Port: 8080 (system service port)

Security Level: Low (Allow all connections)

LCD panel password: (blank)*

VLAN will be disabled

*This feature is only provided by the NAS models with LCD panels. Please
visit http://www.qnap.comfor details.
Advanced system reset (10 sec)
Press the reset button for 10 seconds; you will hear two beeps at the third and the tenth
seconds. The NAS will reset all the system settings to default as it does by web-based
system reset in "Administration" > "Restore to Factory Default" except all the data are
reserved. The settings such as the users, user groups, and the network share folders
previously created will be cleared. To retrieve the old data after the advanced system reset,
create the same network share folders on the NAS and the data will be accessible again.
Power button
(Turn on)
Press once
Basic system reset
(1 beep)
3 sec
39
Power button
(Hardware turn
off)
1.5 sec
Advanced system reset
(2 beeps)
10 sec
Power button
(Force turn off)
5 sec