Chapter 2. Power Button And Reset Button Behavior - QNAP TDS-16489U Series User Manual

Chapter 2.
Power button: Press to turn on or turn off.

System
All models
Reset button: Press to reset the system settings.

System
All models
Basic system reset (3 sec)
Press the reset button for 3 seconds, a beep sound will be heard. The following settings are
reset to default:
System administration password: admin

TCP/IP configuration: Obtain the IP address settings automatically via DHCP

TCP/IP configuration: Disable Jumbo Frame

TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port

trunking mode will be reset to "Active Backup (Failover)".
System Port: 8080 (system service port)

Security Level: Low (Allow all connections)

LCD panel password: (blank)*

VLAN will be disabled.

Service binding: All the NAS services run on all available network interfaces.

*This feature is only provided by the NAS models with LCD panels. Please visit
http://www.qnap.com
Power Button and Reset Button Behavior
Power button
(Turn on)
Press once
Basic system reset
(1 beep)
3 sec
for details.
14
Power button
(Hardware turn
off)
1.5 sec
Advanced system reset
(2 beeps)
10 sec
Power button
(Force turn off)
5 sec