Table of Contents
Advertisement
Connecting the 8300HDC to an External SATA
Hard Disk Drive (optional)
Complete the following steps to install a SATA drive.
1. Make sure that both the 8300HDC and the external
SATA drive are unplugged from power.
2. Connect the data cable for the SATA drive to
the 8300HDC.
3. Plug in power to the external SATA drive.
4. Plug in the 8300HDC power cord, and then turn on the 8300HDC.
5. Follow the on-screen instructions. One of the following occurs:
• If it is a new drive or one used on another device, you are asked to format it.
• If the drive is formatted and will work with this 8300HDC, you get a confirmation that the drive
is working.
Guidelines for Using the External SATA Hard Disk Drive
The external SATA hard disk drive requires continuous power. If the SATA drive loses power while
the 8300HDC is plugged in, the 8300HDC may stop recording or not provide enough sp ace for
future recordings. Follow these guidelines for using the SA TA drive:
• Do not plug in the power cord for the SATA drive to a switched outlet or to the AC outlet on the
8300HDC.
• Do not turn off, disconnect, or unplug the SATA drive while the 8300HDC is plugged in.
Recommendations for the SATA Drive
Contact your cable service provider for a list of approved external SA TA hard disk drives. At a
minimum, your SATA drive should have these cap abilities:
• External SATA Connector - SATA II: Cable and Connector, Revision 1.0 (www.sata-io.org for more
information)
• Drive Speed: 7200 RPM (5400 RPM without Multi-room); 133 MB/sec
• Capacity: Only one SATA drive can be connected to the 8300HDC. The 8300HDC will not
support a separate port multiplier.
• SATA Drive Power: The SATA drive should power on when plugged in and should not be
controlled by a switch.
17
WARNING:
Electric shock hazard! Unplug
all electronic devices before
connecting or disconnecting any
device cables to the 8300HDC.
14
Advertisement
Table of Contents
