Channel Menu; Select Antenna/Cable; Scan Channels - JVC Emerald Series User Manual

Channel Menu

Select Antenna/Cable

Select Antenna or Cable for the service connected to your TV.
1
Press MENU.
2
to select "Channel", then press or OK.
Press or
3
to select "TV Mode", then press OK.
Press or
4
to select "Antenna", or "Cable", then press OK.
Press or

Scan Channels

Auto Scan Channels
When you run auto scan, the TV scans for all available channels. Make sure the antenna/cable is
connected properly.
1
Press MENU.
2
to select "Auto Channel Scan", then press or OK.
Press or
3
to select "Start Scan", then press OK.
Press or
Scanning progress is displayed on the menu screen. To stop scanning, select "Stop Scan" and press OK.
Note: Auto scan may take 15 to 30 minutes to find available channels.
Partial Scan Channels
You can partially scan for network signal within a specified range of channels.
1
Press MENU.
2
to select "Partial Channel Scan", then press or OK.
Press or
3
to select "Scan Mode", then press or OK.
Press or
4
to select an option, then press OK.
Press or
• "Analog/Digital": Scans for both analog and digital channels.
• "Analog": Scans for analog channels.
• "Digital": Scans for digital channels.
5
Press or to select "From Channel", then enter a starting channel range.
6
Press or to select "To Channel", then enter an ending channel range.
7
to select "Start Scan", then press OK.
Press or
Scanning progress is displayed on the menu screen. To stop scan, select "Stop Scan" and press OK.
34
Adjusting the Menu Settings
TV Mode Cable
Auto Channel Scan
Partial Channel Scan
Find Channel
Channel Management
Digital MTS English