Specifications; Instructions For Putting Into Use - Chicago Electric 99702 Set Up And Operating Instructions Manual

speciFicAtiOns

Electrical Requirements
Motor
Operating PSI
Paint Flow
Fuse
Hose Size
Oil Requirement
unpAcKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
instructiOns FOr
putting intO use
read the entire impOrtAnt
sAFety inFOrmAtiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FrOm AccidentAl
OperAtiOn:
turn the power switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
SKU 99702
120 V~ / 60 Hz /
7.5 A
3/4 HP
2350 – 2650 psi
0.33 GPM
Class F, F10A/250 V
1/4"
Hydraulic Oil
tO preVent
seriOus injury
For technical questions, please call 1-800-444-3353.
Assembly
1. Turn the knobs on the handle coun-
terclockwise, pull the handle up, and
secure it by turning the knobs clock-
wise. Repeat with lower knobs to
raise the Sprayer to the correct height
for the job. The Sprayer should be
1/4" above the bottom of the pail.
2. Insert the ends of the hose bracket
into the holes on the inside of the
handle.
3. Remove the hex nuts on the front of
the unit, then use them to secure the
pail bracket to the unit.
pail Bracket
prime/sprAy
Knob
Knobs
REV 08j
Page 9