What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.
Thermal sensor
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove or install the thermal sensor, do the following:
1. Prepare your computer. See "Preparing your computer" on page 96.
2. Locate the thermal sensor. See "FRUs and CRUs" on page 35.
3. To remove the thermal sensor, do the following:
a. Disconnect the thermal-sensor cable from the thermal-sensor connector on the system board. See
"Parts on the system board" on page 38.
b. From the inner side of the chassis, press the left retaining clip that secures the plastic holder of the
thermal sensor and push the clip outward to release the plastic holder. Then, disengage the plastic
holder from the chassis.
Figure 119. Removing the thermal sensor
c. Pull the entire thermal sensor out of the chassis.
4. To install the thermal sensor, do the following:
156
P330 Hardware Maintenance Manual