Switch Cover - HP Compaq 2210b Maintenance And Service Manual

Switch cover

Description
Switch cover (includes LED board and LED board cable)
Before removing the switch cover, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the keyboard (see
5.
Remove the switch cover:
Turn the computer upside down, with the rear panel toward you.
1.
Remove the following:
2.
(1) Two rubber screw covers. The rubber screw covers are included in the Plastics Kit, spare part
number 454010-001.
(2) Three Phillips PM2.5×7.0 screws.
(3) Five Phillips PM2.0×3.0 screws.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
Battery on page 37).
Keyboard on page 47).
Spare part number
454006-001
Component replacement procedures 49