Controlling Audio; 3-Way Speaker System Setup - Kenwood DMX7520DABS Instruction Manual

Controlling Audio

You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU] button.
h Popup menu appears.
h
2
Touch [Audio].
See the following section for each setting.
• Set up Speaker / X'over (P.66)
• Controlling EQ / SW Level (P.68)
• Set Position / DTA (P.72)
• Controlling Fader / Balance (P.68)
• Set Volume Offset (P.69)
• Performing Zone Control (P.70)
• Set Sound Effect (P.71)
• Use Audio Memory (P.73)

3-way speaker system setup

Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [HOME] button.
h HOME screen appears.
h
2
Touch [
].
h Source selection screen appears. h
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
1
h Speaker system select screen appears.
h
5
Select the crossover network mode.
h A confirmation screen appears.
h
6
Touch [Yes].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.
Controlling Audio
2
65
English