Table of Contents
Advertisement
54
www.aeg.com
Problem
The washing results
are not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
The detergent/fabric
softener level does not
decrease in the Auto‐
Dose tanks after wash‐
ing.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
15.2 Emergency door
opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water temperature
is not too high and the
laundry is not hot. If
necessary, wait until they
cool down.
Possible solution
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before
you wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
When using AutoDose tanks, make sure that they are not
empty.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
Make sure that you have cleaned the AutoDose tanks before
using different brand and type of detergent, fabric softener or
other additives.
•
Reduce the quantity of detergent.
•
When using AutoDose tanks, verify the pre-set detergent/
fabric softener dosage. Refer to "Basic setting" paragraph in
"The AutoDose Technology" chapter.
•
This is normal: tanks are quite large and detergent consump‐
tion may be not so evident.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Make sure that the water
level inside the drum is
not too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
To open the door, proceed as follows:
1. Press the Aan Uit/Marche Arrêt
button to switch the appliance off.
2. Disconnect the mains plug from the
mains socket.
3. Open the filter flap.
Advertisement
Table of Contents
