Table of Contents
Advertisement
17. Installation and Levelling
Fig. 17.1
SECURE THE MAINS CABLE USING THE 'P' CLIPS FOR LEFT OR RIGHT HAND CABLE MANAGMENT.
SECURE THE MAINS CABLE USING THE 'P' CLIPS FOR LEFT OR RIGHT HAND CABLE MANAGMENT.
DESN 517951
Fig. 17.2
DESN 517647
Fig. 17.3
DESN 516895
Fig. 17.4
MAKE SURE THE SIDE PLINTH
MAKE SURE SIDE PLINTH
SKIRTS LOCATE IN THE
SKIRTS LOCATE IN THE GUIDE
GUIDE SLOTS PROVIDED
SLOTS BRACKET
DESN 517949
STABILITY FOOT
USE A 12MM OPEN END SPANNER
TO MAKE FINE ADJUSTMENT.
FRONT PLINTH COVER
FRONT PLINTH COVER
FITS OVER SIDE SKIRTS
FITS OVER SIDE SKIRTS
1.
NOTE: Care must be taken not to trap mains cables (Fig.
17.1).
2.
When removing appliance from the pallet, the front
stability feet can be raised with a spanner to allow
appliance to be slid from transit pallet (Fig. 17.2).
3.
Slide cooker off transit pallet.
4.
Appliance can now be pushed back on its wheels into
desired position. NOTE: Care must be taken not to trap
mains cable.
5.
Levelling of appliance - Use 12mm socket to adjust
wheel mechanism for FINE adjustment on both sides at
rear of the appliance (Fig. 17.3).
6.
Using a 13mm open end spanner, feet can be adjusted
at front to make FINE adjustments to the front of the
appliance and to provide a brake for the wheels (Fig.
17.3).
7.
Turning the bolt clockwise will lower the wheel thus
increasing height of the cooker (Fig. 17.3).
8.
Anti-clockwise lifts the wheels and lowers the cooker
(Fig. 17.3).
9.
Fit the magnetic plinth (Fig. 17.4) and sides.
31
Advertisement
Table of Contents
