Whirlpool WRF57R18DM User Manual page 5

Handle
A
A. Grommet
B. Handle
C. Setscrews
Refrigerator Leveling and Door Closing
Your refrigerator has two front adjustable legs, one on each side. The
back of the refrigerator rests on two fixed rollers. The base grille covers
the adjustable brake feet and roller assemblies located at the bottom of
the refrigerator below the refrigerator door. Before making any
adjustments, remove the base grille and move the refrigerator to its
final location.
Tools Needed: ¹⁄₄" hex driver, Phillips screwdriver
1. Remove the base grille screws. Grasp the grille firmly and pull it
toward you. Open the refrigerator door to access the brake feet.
NOTE: To allow the refrigerator to roll more easily, raise the brake
feet by turning them counterclockwise. The front rollers will be
touching the floor.
Door Removal and Replacement
B
C
2. Move the refrigerator to its final location.
3. Lower the brake feet, by turning them clockwise, until the rollers
are off the floor and both brake feet are snug against the floor.
This keeps the refrigerator from rolling forward when opening the
refrigerator door.
IMPORTANT: If you need to make further adjustments involving the
brake feet, you must turn both brake feet the same amount to keep
the refrigerator level.
4. Make sure the door closes easily. If you are satisfied with the door
opening and closing, skip the next section. If, however, the door
does not close easily or the door pops open, adjust the tilt.
5
Top Hinge
A
B
B
C
A. Top Hinge Cover
B. 5 / " Hex-Head Hinge Screws
16
C. Top Hinge
Bottom Hinge
A
B
A. Hinge Pin
B. 3 / " Hex-Head Hinge Screws
8