Test Run - Grizzly G0642 Owner's Manual

Test Run

Once the setup and assembly are complete, test
run your machine to make sure it runs properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 23.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Read and follow the safety instructions at
the beginning of the manual, make sure the
machine is setup properly.
2.
Make sure all tools and objects used during
set up are cleared away from the machine.
3. If there are boring bits installed in the machine,
remove them.
4. Make sure the boring head guard is in place
and is free to move up as the boring head
assembly comes down.
5. Connect the machine to the power source.
6.
Verify that the machine is operating correctly
by turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
-14-
7. Turn the machine OFF.
8. Insert the switch disabling pin through the
green ON button, as shown in Figure 11.
Figure 11. Switch disabling pin installed.
9. Press the green ON button to test the dis-
abling feature on the switch.
—If the machine does not start, the switch
disabling feature is working as designed.
—If the machine starts, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Model G0642 15-Bit Line Boring Machine