16. ACCESSORIES......................37 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
The operating water pressure at the water entry point • from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be • covered by a carpet, mat, or any floor covering.
ENGLISH 2.2 Electrical connection 2.4 Use • The appliance must be earthed. WARNING! • Always use a correctly installed Risk of injury, electric shock, shockproof socket. fire, burns or damage to the • Make sure that the parameters on the appliance.
Page 6
3.1 Unpacking WARNING! Remove all the packaging and the transit bolts before installing the appliance. WARNING! Use the gloves. 1. Remove the external film. If 5. Carefully put down the appliance necessary, use a cutter. with the rear side on it.
Page 7
ENGLISH We recommend that you 9. Remove the power supply cable and keep the packaging and the the drain hose from the hose holders. transit bolts for any movement of the appliance. It is possible to see 3.2 Positioning and levelling water flowing from the drain hose.
Page 8
4. Connect the water inlet hose to the A correct adjustment of the cold water tap with 3/4" thread. appliance level prevents the vibration, noise and the movement of the appliance when in operation. When the machine is installed on a plinth or if a...
ENGLISH 5. Without the plastic hose guide, to a sink spigot - Put the drain hose in Make sure that the drain the spigot and tighten it with a hose end is not immersed in clamp. Refer to the illustration. the water.
Page 10
• Thanks to the Soft Plus option, the they need little ironing. fabric softener is uniformly spread out The Plus Steam option, finishes every in the laundry and deeply penetrates cycle with gentle steam that relaxes the fabric fibres favouring a perfect the fibres and reduces fabric creasing.
ENGLISH 5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Delay start touch button (Delay Start) Display Steam Plus touch button (Plus Steam) Eco touch button (Eco) Time saving touch button (Time Spin reduction touch button (Spin) Save) •...
Page 12
5.2 Display Maximum load indicator. The indicator flashes during the laundry load estimation (refer to ProSense load detection paragraph) . Maximum laundry indicator. It blinks if the laundry amount exceeds the declared load. Door locked indicator. Delay start indicator.
ENGLISH Spin speed indicator. Rinse hold indicator. Extra Silent indicator. Temperature indicator. The indicator appears when a cold wash is set. 6. DIAL AND BUTTONS 6.1 On/Off When the display shows the indicators , the appliance does not Pressing this button for a few seconds heat the water.
Page 14
This option is not You must drain the water to unlock available with a the door. temperature lower than As the programme is very quiet, it is 40 °C. suitable for use at night time when •...
ENGLISH the selected delay time and the The display shows the indicator appliance begins the countdown. This option can also be used 6.8 Rinse to shorten the Steam programme duration. With this button you can select one of the following options: 6.10 Eco •...
Page 16
Programme Programme description White cotton and coloured cotton. Normal, heavy and light soil. Cottons Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, the programme Cottons at 60 °C and the programme Cottons at 40 °C with the option are respectively the «Standard 60°C cotton pro-...
Page 17
ENGLISH Programme Programme description Do not use fabric softener and make sure that Outdoor there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.5 kg. This programme can also be used as water-repellent restoring cycle, specifically tailored for treating clothes with a hydropho- bic coating.
Page 18
Programme Default tempera- Maximum spin speed Maximum load ture Spin speed range Temperature range 40 °C 1200 rpm 3 kg 40 °C - Cold 1200 rpm - 400 rpm Delicates 40 °C 1200 rpm 1.5 kg 40 °C - Cold...
8. SETTINGS 8.1 Introduction • The appliance has a malfunction (sequence of short sounds for about 5 When pressing a key minutes). combination, do not tilt To deactivate/activate the acoustic your fingers downwards . signals when the programme is...
ENGLISH 4. Pour a small quantity of detergent This removes all possible dirt from the into the compartment marked by drum and the tub. 5. Set and start a programme for cotton at the highest temperature without any laundry in the drum. 10.
Page 22
After a washing cycle, if necessary, remove any detergent residue from the detergent dispenser. 10.4 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser.
Page 23
ENGLISH Cancelling the delay start after The display shows the maximum declared load for the programme, the the countdown has started default temperature, the maximum spin speed, the washing phase indicators To cancel the delay start: (when available) and an indicative 1.
Page 24
10.10 Interrupting a In this case, for 30 seconds, it is possible to pause the appliance and remove the programme and changing the exceeding garments. options Once removed the exceeding garments, When the programme is running, you touch the Start/Pause button to start the can change only some options: programme again.
Page 25
ENGLISH 3. Close the door and touch the button • The drum still turns at regular intervals Start/Pause. to prevent the creases in the laundry. The programme or the delay start • The door stays locked. continues. • You must drain the water to open the door: 10.13 End of the programme 1.
11. HINTS AND TIPS Special stain removers are available. Use WARNING! the special stain remover that is Refer to Safety chapters. applicable to the type of stain and fabric. 11.1 The laundry load 11.3 Detergents and other treatments • Divide the laundry into: white, coloured, synthetics, delicates and •...
ENGLISH 11.5 Water hardness To find out the water hardness in your area, contact your local water authority. If the water hardness in your area is high Use the correct quantity of water or moderate, we recommend that you softener. Follow the instructions that you use a water softener for washing find on the packaging of the product.
Page 28
12.6 Cleaning the detergent dispenser To prevent possible deposits of dried detergent or clotted fabric softener and/or formation of mould in the detergent dispenser drawer, once in a while carry out the following cleaning procedure: 1. Open the drawer. Press the catch downwards as indicated in the picture and pull it out.
Page 29
ENGLISH WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover. 5.
Page 30
12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter.
ENGLISH 12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 32
The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Authorised Service Centre. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre.
Page 33
ENGLISH Problem Possible solution • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Make sure that the drain filter is not clogged. Clean the fil- ter, if necessary. Refer to "Care and cleaning". The appliance does not •...
Page 34
Problem Possible solution • Increase the detergent quantity or use a different deter- gent. The washing results are • Use special products to remove the stubborn stains before not satisfactory. you wash the laundry. • Make sure that you set the correct temperature.
ENGLISH 5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature.
Programmes Load Energy Water Approxi- Remain- (kg) consump- consump- mate pro- ing mois- tion (kWh) tion (litre) gramme ture (%) duration (minutes) 0.46 Standard 40°C cotton 1) At the end of spin phase. Off Mode (W) 0.30 Left On Mode (W) 0.30...
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.