Table of Contents
Advertisement
6
BEFORE SETTING OVEN CONTROLS
Oven Vent
The oven vent is located under the control panel
When the oven is operational, warm air will pass through this
vent for proper air circulation and provide good baking results in
the oven. Steam or moisture may appear near the vent, this is
normal. Do not block this vent.
Figure 1:
Oven vent
Oven Racks
removing food or adjusting the oven racks. Wait until the oven
has completely cooled if possible. Oven racks may be very hot
and may cause burns.
Removing and replacing flat or offset oven racks
•
To remove - pull the oven rack straight forward until it
reaches the stop position. Lift up front of oven rack slightly
and slide out.
•
To replace - place the oven rack on the rack guides on the
oven walls. Tilt the front of the rack upward slightly and
slide the oven rack back into place.
Flat oven racks may be used for most cooking needs and may
be placed in most oven rack
The fully extendable Luxury-Glide™ oven rack
allows you to effortlessly extend your food away from the oven.
See Removing and Replacing the Luxury-Glide™ Oven
Racks on next page for instructions.
Always use potholders or oven mitts when
positions.(Figure
Types of oven racks
(Figure
1).
Your appliance may be equipped with any one or more of the
following rack types.
oven vent
location
Figure 2:
2)
(Figure
3)
Figure 3:
IMPORTANT! Do not line oven walls, racks, bottom or any
other part of the oven with aluminum foil. Doing so will alter heat
distribution, produce poor baking results, and may cause
permanent damage to the oven interior. During a self clean
cycle oven temperatures will be hot enough to melt foil.
flat
oven rack
Flat rack for most baking
Luxury Glide™
Luxury Glide rack
flat handle
oven rack
Advertisement
Table of Contents
