Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Siemens EB6B P Series
Summary of Contents for Siemens EB6B P Series
- Page 1 Gas hob EB6B.P.., EB6B.H.., EB6B.C..en Instruction manual...
- Page 2 Pan supports Control knobs " Economy burner with an output of up to 1 kW Standard-output burner with an output of up to 1.75 kW High-output burner with an output of up to 3 kW Mini wok burner up to 3.3 kW &...
-
Page 3: Table Of Contents
Special attention shall be paid to ventilation regulations. -
Page 4: Important Safety Information
Important safety information cooking purposes, not as a heating system. (Important safety The warranty will only be valid if the appliance information is used for the purpose for which it was designed. Warning – Risk of deflagration! This appliance is intended for use up to a i n f o r m a t i o n I m p o r t a n t s a f e t y Accumulation of unburned gas in an enclosed... -
Page 5: Getting To Know Your Appliance
Getting to know your appliance Warning – Risk of injuries! *Getting to know your Pans which are damaged, are not the right ■ appliance size, hang over the edge of the hob or are not positioned correctly can cause serious injuries. -
Page 6: Gas Burners
Gas burners Code Warning – Risk of deflagration! HZ298108 Additional wok grid: cast iron (3.3 kW) If after 15 seconds the flame does not ignite, switch off HZ298110 Additional wok grid: Enamelled steel the burner and open a nearby window or door. Wait at HZ298114 Additional espresso maker grid least one minute before trying to switch the burner back HZ298105 Simmer Plate... -
Page 7: Cooking Guidelines
Cooking pans Keep the burner as clean as possible. If the ignition Instructions for use sparkers are dirty they will not light properly. Clean When using certain pots or pans, a slight and Note: them periodically using a small non-wire brush. Bear in temporary deformation of the steel cooking surface may mind that the ignition sparkers must not suffer any occur. -
Page 8: Cleaning And Maintenance
Cleaning and maintenance Caution! 2Cleaning and maintenance Do not remove the control elements when cleaning ■ the appliance. The appliance may be damaged if moisture finds its way inside. Cleaning t e n a n c e C l e a n i n g a n d m a i n Do not use steam cleaners. -
Page 9: Customer Service
Customer service Fault Possible cause Solution The burner immediately The control knob was not held down for long enough. Once the burner is on, hold the control knob down a few switches off after releasing the seconds longer. control knob. The grooves on the burner are dirty. - Page 12 *9001045188* 9001045188 970407(D)