Step 6 - Install Microwave Oven - Haier HMV1652 Installation Instructions Manual

STEP 6 - INSTALL MICROWAVE OVEN

Install the microwave oven following the instructions specific to your method.
METHOD A - OUTSIDE TOP EXHAUST (VERTICAL DUCT)
IMPORTANT:
•
Make sure the screws for the blower motor and blower plate are securely
tightened when they are reinstalled. This will help to prevent excessive vibration.
•
Make sure the motor wiring has been properly routed and secured, and that the
wires are not pinched.
Attach the mounting plate to the wall using toggle bolts.
NOTE: At least one wood screw must be used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the holes designated to go into
drywall and reattach the toggle wings onto each bolt.
3. Place the mounting plate against the wall and insert the toggle wings into the
holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on
the mounting plate touch the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under the cabinet.
d
e
a
f
b
CAUTION: Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
12
a
b
c
d
e
f
c
Mounting Plate
Wall
Bolt End
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Toggle Bolt