Electrolux SB330NIMS User Manual page 101

Problem
The compressor does not
start immediately after
pressing the "Extra
Freeze", or after changing
the temperature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
The lamp does not work.
There is too much frost
and ice.
Water flows on the rear
plate of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Possible cause
The door is not closed cor‐
rectly.
The Extra Freeze function
is switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Door was open too fre‐
quently.
Door was not closed com‐
pletely.
ENGLISH
Solution
Refer to the "Closing the
door" section.
Refer to the "Extra Freeze
function" section.
This is normal, no error
has occurred.
Refer to the installation in‐
structions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to the "Closing the
door" section.
Refer to the "Closing the
door" section.
Wrap the food products
better.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
This is correct. Dry the wa‐
ter with a soft cloth.
Open the door only when
necessary.
Make sure the door is
closed completely.
101