Table of Contents
Advertisement
RIGHT REAR
(7) lug
(8) slot
(9) brake panel
(7)
(8)
(9)
Installation
1.
Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
7
slot ( ) in the brake panel ( ). Check that
8
the chain adjusters are installed properly.
2.
Adjust the drive chain (page
3.
Torque the rear axle nut to:
43 lbf·ft (59 N·m , 6.0 kgf·m)
4.
Adjust the rear brake (page
5.
Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
Wheels
9
102
).
85
).
Servicing Your Honda
93
Advertisement
Chapters
Table of Contents
