Table of Contents
Advertisement
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
8 Basic operation
8.1 Switching on the appliance
Requirement: Align the remote control as precisely as
possible to the infrared receiver for the LED display.
Press
to switch on the appliance.
▶
a The appliance starts at fan setting 2.
a The LED for fan setting 2 lights up in the LED dis-
play.
a The appliance moves to the last saved position.
8.2 Switching off the appliance
Switch the appliance off when you are not using it.
Press
to switch the appliance off.
▶
a The fan run-on is switched on, LED 6 flashes in the
LED display for the fan run-on.
a The appliance moves into the fan run-on position.
a The fan automatically switches off after approx. 10
minutes.
a The appliance moves up as far as it will go.
8.3 Lift function
The appliance detects the last selected position and
stores this automatically. When the appliance is next
switched on, it moves into this position, provided no
other position is set.
Note: Further settings relating to the position of the ap-
pliance are available in the Home Connect app.
Moving the appliance down
Press .
▶
a The appliance moves down.
Note:
¡ Briefly press
to move the appliance down into the
last saved position.
¡ Press and hold
for approx. 3 seconds to move
the appliance down as far as it will go.
Moving the appliance up
Press .
▶
a The appliance moves up.
Note:
¡ Briefly press
to move the appliance up into the
last saved position.
¡ Press and hold
for approx. 3 seconds to move
the appliance up as far as it will go.
8.4 Selecting a fan setting
Press
or
.
▶
a The LED for the set fan setting lights up in the LED
display.
1
Depending on the appliance specifications
Before using for the first time en
8.5 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Press
repeatedly until LED 4 lights up in the LED
1.
display for intensive mode 1.
Press
repeatedly until LED 5 lights up in the LED
2.
display for intensive mode 2.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
8.6 Switching off intensive mode
To select a fan setting of your choice, press
▶
8.7 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
The fan run-on removes remaining odours and is used
to dry the odour filter after the cooking process.
a LED 1 for the fan setting lights up in the LED dis-
play. LED 6 flashes for the fan run-on.
a The appliance switches off automatically after ap-
prox. 10 minutes.
8.8 Switching off the fan run-on
Press
.
▶
a This temporarily stops the fan run-on.
8.9 Intermittent ventilation
With interval ventilation, the ventilation system switches
on and off in the selected setting for the selected time.
Note: This function is only available via a mobile device
with the Home Connect app.
If the interval ventilation is switched on, LED 6 continu-
ously flashes in the LED display for the interval ventila-
tion and the LED for the selected fan setting lights up.
As soon as the ventilation time ends, the LED for the
fan setting you have selected goes out. LED 6 contin-
ues to flash.
8.10 Switch on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press
.
▶
a In the LED display, LED 6 lights up for automatic
mode.
.
1
7
Advertisement
Table of Contents
