Table of Contents
Advertisement
settinGs
6
Select the line »DISEqC Mode« with »
or »
«.
Λ
Select »DiSEqC 1.0« or »DiSEqC 1.1« in
a ccordance with the existing antenna system
<
>
with »
« or »
«.
– D iSEqC 1.0 allows up to four satellites to
be received simultaneously.
– D iSEqC 1.1 allows up to 16 satellites to be
received simultaneously.
7
Select the line »LNB Selection« with »
»
«.
Λ
Select the setting for the respective satellites
<
>
with »
« or »
«.
8
Once the settings for the satellite have been
made, switch to the »AUTOMATIC CHAN-
NEL SEARCH« menu with »« (red).
SOURCE SETUP
AUTOMATIC CHANNEL SEARCH
Connection Type
Operator Selection
Select Satellite
Scan Mode
Service Type
Network Search
9 Select the line »Scan Mode« with »
or »
«.
Λ
Select the scan mode with »
(for unencrypted channels, for encrypted
channels only, or for both).
10 Select the line »Service Type« with »
or »
«.
Λ
<
>
Use »
« or »
« to select whether you want to
search for television channels only (TV), radio
stations only (Radio) or both ( Radio + TV).
1 6
enGlish
-----------------------------------------------------------------------------------------------------------------------------------------
08.08.2012
Satellite
Other
ASTRA 19.2°,E
Free + Scramble
All
Off
Exit
Start Search
Back
<
« or »
note:
«
v
It is possible, that some TV channels (tran-
7
sponders) cannot be found. This is caused
by a change in satellite parameters made
by the broadcaster, e.g. new channels have
been added. Set the »Network Search« op-
tion to »On«.
11 Start the scan with »
– T he »Results« menu appears, and the scan
« or
for TV channels begins.
v
– D epending on the number of television
channels received, this can easily take a
few minutes.
– T he scan is complete as soon as the »PRO-
GRAM TABLE« appears.
note:
You can abort the scan by pressing »exit«.
7
12 Press »exit« to end the setting.
15:46
note:
If other television channels are to be tuned
7
from a second satellite, proceed as follows:
Open the menu with »menu«, select the
line »SOURCE SETUP« with »
and press »oK« to confirm. Then select the
» Automatic Channel Search« with »
»
« and press »oK« to confirm. Confirm
Λ
the line » Select Satellite« with »oK« and
s elect the p referred satellite with »
<
»
« or »
Continue the adjustment by step 7 of the
chapter.
note:
B efore recording HD channels, please
7
check signal quality and Strength, see
«
v
chapter "Displaying signal information" on
>
page 64. If the level is displayed in green,
«
you can record HD channels without any
problems.
«
v
« (red).
>
«. Start the scan with »
« or »
«
v
Λ
« or
v
«, »
«,
v
Λ
« (red).
Advertisement
Table of Contents
